Published on Dec 29, 2014 by Grant Thompson – “The King of Random”
How to recycle scrap metal in the backyard, with a homemade, Mini Metal Foundry.
For other project videos, check out http://www.thekingofrandom.com
Music by Scott & Brendo (“Skyward” – Instrumental) http://bit.ly/ScottBrendoiTunes
Project inspired by: This foundry is an original design, which comes after months of experimenting, and over 10 different prototypes. The functionality is founded on ideas I collected while searching the internet for foundry designs.
WARNING: Charcoal foundries can reach temperatures in excess of 1,000ºC, which is well above the melting point of hobbyists. This project should only be attempted with adequate knowledge and training, proper protective safety gear, and in a fire resistant area with adequate ventilation. The sparks flying from the foundry can ignite fires, and the fumes from burning dross can be toxic. Use caution and common sense. Use of this video content is at your own risk.
For as long as I can remember, I’ve been intrigued by the idea of melting metal and making things with it. The problem has always been that it was out of reach or required really expensive equipment.
In this project I experimented with 10 different prototypes, to develop a reusable backyard foundry that melts aluminum soda cans easily and safely. I tested different refractory recipes, different containers, different setting for blowing air, and different types of makeshift crucibles.
I tried various ratios of portland cement, sand, perlite, plaster of paris, water, and even kitty litter. For containers, I experimented with clay pots, plastic buckets, no container, cinderblocks, and a galvanized steel pail.
I ended up favoring the galvanized steel pail, and a mix of 50% plaster of paris, and 50% play sand, by volume, which was inspired by a video by NightHawkInLight “How to Make a Soup Can Forge”http://bit.ly/IBSoupCanForge
Depending on where you get, or find, your materials the cost can range anywhere from $5-$25 per unit. With the materials I used, I was able to make 2 units for under $40 ($20 each). Even on the high end, this is probably one of the cheapest, reliable, backyard foundries that can be made.
I used mine to melt soda cans, and extract the aluminum for future metal casting projects. All the soda cans came from a local recycling depot. I bought back 30 lbs from the depot to avoid having to drink gallons and gallons of soda. 🙂 I stored the ingots in various forms, which you can see in the next video, and tried a cool technique for making a little sword by pouring liquid metal into a bucket of sand. I’m planning to make a project video on how to do that in the near future.
Thanks for watching, and please share!! 🙂